STB HY100 blocked at boot

Started by chiochiaro, 04. Dec 2012, 09:21

previous topic - next topic
Go Down


Dear all,
I tried to perform a firm change on my PIRELLI STB (ALICE) HY100 receiver.

I have executed the procedure for the HY101.
The procedure has gone ok, but when i try to reboot the receiver to load the new firm from USB the receiver can't load the firm.

I tried to plugin the ethernet, but the receiver does not acquire the IP address from DHCP, so i can't communicate with him.

I know that probably I executed an wrong procedure, because I have an HY100 instead of an HY101.

Anyone know how I can recover my HY100?

Go Up